1.800,00 EGP



MKS GEN L V1.0 main control board features advantages:
1. The 2560 and ramps1.4 are assembled on one board, which solves the problem that the Ramps1.4 combination interface is cumbersome and easy to malfunction.
2, the user can replace the motor drive, support 4988 drive and 8825 drive, TMC2100 drive
3. Reserve an external drive signal, which can be connected to a large drive to drive the 57 and 86 motors.
4, the use of high-quality MOSFET tube, better heat dissipation, to ensure long-term stability.
5, using a dedicated power chip, support 12V-24V power input, to solve the problem of heat and power supply of Ramps voltage conversion chip.
6. The stable and reliable filter circuit greatly reduces the possibility of interference and is the most likely to avoid the phenomenon of crashes and runaways during the printing process.
7, using a CH340 serial chip, under the premise of ensuring stability and reliability, reduces costs, but also solves the problem of the previous 16U2 hard-to-install drive.
8, can accept 24V input, and the same system power can reduce the hot bed current to 1/4, effectively solving the hot bed MOS tube heating problem.
9, using the open source firmware Marlin, the configuration and ramps1.4 are exactly the same, can directly replace Ramps1.4.
10, can directly connect 2004LCD display and 12864LCD display, can support TFT28, TFT32 touch screen convenient wiring.
TMC2209 2.1 Product Description?
Hardware compatible with StepStick and Pololu A4988
Drive capability up to 1.7A (RMS) continuous coil current – 2.8A Peak
Step/Dir interface with micro step interpolation (up to 256 microsteps)
Configuration via CFG pins or UART interface
Motor voltage: 5.5…28V
Logic voltage: 3.3…5V
RSense: 0.11 Ohm
stealthChop2 – for quiet operation and smooth motion
spreadCycle – highly dynamic motor control chopper (enableable via UART, OTP, CFG Pin) cool step – current control for energy savings